Jailbreak Apple TV 2G iOS 4.2.1 with Seas0nPass

by on February 18th, 2011

Seas0nPassFollowing methid will guide you about how to jailbreak Apple TV with Seas0nPass jailbreak tool, which can create custom firmware like PwnageTool. Currently the jailbreak for the 4.2 (iOS 4.3) software is ‘tethered’. A tethered jailbreak requires the AppleTV to be connected to a computer for a brief moment during startup. Seas0nPass makes this as easy as possible, but do not proceed unless you are comfortable with this process.

Requirements

  • Make sure you’re running the latest version of iTunes.
  • Download Seas0nPass: Mac [10.6 or later] | Windows [XP or later]
  • A micro USB cable will be required to complete the jailbreak.
  • Disconnect all iPods, iPhones, and iPads from the computer before running Seas0nPass.

Using Seas0nPass to jailbreak the AppleTV

Unzip the ‘Seas0nPass.zip’ file and launch Seas0nPass.

SP-launch

If your AppleTV is not yet jailbroken, select ‘Create IPSW’. (if already jailbroken, and you just need to do a ‘tethered boot’ scroll down).

2-SP-main

The latest AppleTV software will be downloaded and used to create a custom ‘jailbroken’ software file.

3-SP-create

When prompted, connect your AppleTV using a micro-USB cable (leave power disconnected), and hold both the ‘MENU’ and ‘PLAY/PAUSE’ buttons for 7 seven seconds.

4-SP-restore

iTunes will open automatically and start the restore process.

5-SP-itunes

iTunes will confirm the restore when complete – your AppleTV is now jailbroken. Please proceed to the ‘tethered boot’ section below.

Using Seas0nPass for a ‘tethered boot

Some AppleTV software versions require a tethered boot. This means the AppleTV must be connected to a computer for a brief moment during startup. The AppleTV MUST be disconnected from the computer (for at least a brief moment) after restoring in iTunes for the tethered boot process below to work properly.

Open Seas0nPass and select the ‘Boot Tethered’ option.

1-1-SP-main

When prompted, connect the AppleTV to your computer via USB. Wait for the rapid flashing light then connect the power. Once both are connected hold both the ‘MENU’ and ‘PLAY/PAUSE’ buttons for 7 seven seconds.

1-2-SP-tetherprompt

Seas0n Pass will complete the tethered boot automatically. Once complete, remove the USB cable and connect the HDMI cable. Timing is key. Once you receive the success message shown below, the USB cable should be removed and HDMI cable connected before the light on the front of the AppleTV stops flashing. (Don’t worry there is ample to do this, so you don’t need Superman speed).

1-3-SP-tethercomplete

via


Share